Support for twin choke horizontal carburettor
Solex Ø 32/32 or Ø 35/35 mm (Lancia Fulvia derivation)
For Fiat 500 F/L/R and Fiat 126
Note: To complete the installation, requires two welding points, this is to allow adjustment based on the length of the manifold
Additional information
| Weight | 0,6 kg |
|---|---|
| Models | |
| Material |
Related products
-
Plate to reinforce cylinder block Ø 77 mm
Out of stock
58,00€ Read moreSteel plate to reinforce cylinder block For cylinders Ø 77 mm Holes size Ø 83 mm – H 10 mm Fiat 500 F and Fiat 500 L
-
Plate to reinforce cylinder block Ø 79,5 mm
In stock
58,00€ Add to cartSteel plate to reinforce cylinder block For cylinders Ø 79,5 and 80 mm Holes size Ø 85 mm – H 10 mm Fiat 500 F and Fiat 500 L
-
Set of Pushrod Covers
Out of stock
99,00€ Read moreSet of pushrod covers 5 pieces For Fiat 500 F/L/R and Fiat 126
-
Reinfoced engine spring Fiat 500 F/L
In stock
18,00€ Add to cartReinforced engine spring Calibration + 30% For Fiat 500 F and Fiat 500 L
You may also like…
-
Support for twin choke carburettor Ø 40/40
Out of stock
39,00€ Read moreSupport for twin choke horizontal carburettor Weber, Dell’Orto,Solex Ø 40/40 mm, Alfa Romeo derivation (Weber, Dell’Orto, Solex) For Fiat 500 F/L/R and Fiat 126
-
Support for twin choke carburettor Ø 45/45
In stock
39,00€ Add to cartSupport for twin choke horizontal carburettor Weber, Dell’Orto,Solex Ø 45/45 mm, Alfa Romeo derivation (Weber, Dell’Orto, Solex) For Fiat 500 F/L/R and Fiat 126
